Walleye Discussion Forums

Forums | Calendars | Albums | Quotes | Language | Blogs Search | Statistics | User Listing
You are logged in as a guest. ( logon | register )
View previous thread :: View next thread
Jump to page : 1
Now viewing page 1 [25 messages per page]

Walleye Fishing -> Walleye Boats and Motors -> Yamaha 200 HPDI Cold Start Problem
 
Message Subject: Yamaha 200 HPDI Cold Start Problem
Purple Skeeter
Posted 10/28/2014 6:34 AM (#112679)
Subject: Yamaha 200 HPDI Cold Start Problem


Member

Posts: 885

My Yamaha 200 HP HPDI will not start in colder temps until I click the key on and off for about a minute in colder damp conditions.

I was up in Escanaba this past week and it did the same thing every morning.

I have 3 new batteries and the connections are tight. My T-8 which is hooked to the same starter battery starts fine.

After the initial problem, it will start every time with no problem.

Anyone else every experience this
Top of the page Bottom of the page
sworrall
Posted 10/29/2014 7:53 AM (#112683 - in reply to #112679)
Subject: RE: Yamaha 200 HPDI Cold Start Problem




Location: Rhinelander
It doesn't turn over at all until you manipulate the key position?
Top of the page Bottom of the page
Purple Skeeter
Posted 11/1/2014 1:47 PM (#112697 - in reply to #112679)
Subject: RE: Yamaha 200 HPDI Cold Start Problem


Member

Posts: 885

Upon turning the key the first time in the cold damp conditions, you can hear a click in the motor like a solenoid engaging but the starter will not move and the motor does not attempt to turn over.

After you click the key on and off each time you hear the solenoid clicking. After about a minute of clicking on/off, it starts great and then fires up with no problems every time you try.

Top of the page Bottom of the page
ranger618
Posted 11/9/2014 6:25 PM (#112722 - in reply to #112679)
Subject: Re: Yamaha 200 HPDI Cold Start Problem


New User

Posts: 2

It may be bad brushes in the starter motor.
Top of the page Bottom of the page
Purple Skeeter
Posted 11/12/2014 6:47 AM (#112725 - in reply to #112679)
Subject: RE: Yamaha 200 HPDI Cold Start Problem


Member

Posts: 885

Replaced starter... thanks to Anchor Marine in Appleton I was able to replicate the problem. The starter was slow to raise and engage the flywheel. Eric replaced the starter and everything is working well.
Top of the page Bottom of the page
Jump to page : 1
Now viewing page 1 [25 messages per page]
Jump to forum :
Search this forum
Printer friendly version
E-mail a link to this thread
Lund Boats

(Delete all cookies set by this site)