|
|
Member
Posts: 1040
Location: Stevens Point, WI | Looking for a 24 volt Minn Kota Maxxum/Fortrex 80lb. or a Motorguide Tour Edition 82lb. trolling motor with a 62 inch shaft.
Would consider 52 inch shaft.
Email me at [email protected] or pm here. |
|
| |
|
Member
Posts: 7
| Tj I suck at computers. I have a 36 volt Minn Kota Maxxum 101 that has been used no more than a dozen times. It has a 52' shaft. I think it probably is way over kill for my Muskie Rampage. I have not mounted it yet. Just putting it out there. |
|
| |
|
Member
Posts: 7
| I just measured the shaft it is a 62" not a 52". |
|
| |
|
Member
Posts: 1040
Location: Stevens Point, WI | Thanks for the checking, man. My setup is for a 24 volt motor, not a 36, otherwise I'd be interested. Thanks though. |
|
| |
|
| I have a 2005 Model 60" Maxxum 80lb thrust. Everything works except for the built in transducer. Since it was the older transducer w/o temperature I didn't fix it and installed a external lowrance transducer. Email me at [email protected] if interested |
|
| |
|
Member
Posts: 2300
Location: Berlin | I have a 101 Fortrex with a 45" shaft that I am not willing to sell. Just thought I would let you know. |
|
| |
|
Member
Posts: 1040
Location: Stevens Point, WI | LOL. That's good to know, Rich, I don't care for a motor with a little shaft, ha.
Edited by TJ DeVoe 5/21/2012 1:18 PM
|
|
| |
|
Member
Posts: 7
| I just put it out there. It will be one heck of a trolling motor on a Muskie Rampage. |
|
| |
|
| I want a auto-pilot. [email protected] |
|
| |
