|
|
Member
Posts: 591
Location: in the boat off the east shore somewhere | i need a good kuel protector ,, what can i expect to pay installed? and are there any that i should stay away from or are they all pretty much the same thing... i know there on the bottom of the boat and dont get much publicity but any tips? |
|
| |
|
Member
Posts: 3899
| Hamby's. I've never put one on, but I do know they must be applied right, or you'll be redoing it. Uses that 3M adhesive, that sets immediately.
I don't know who installs locally, but I be Hamby's probably has a list. Give them a shout.
Edited by Shep 10/2/2007 7:48 AM
|
|
| |
|
Member
Posts: 591
Location: in the boat off the east shore somewhere | thanks shep ill do some homework, also any other idia.? glass boat... i know how important a kuel is for trolling strait at low speeds and safty at high speeds turning and the such.. i dont want to screw up boat controle buy putting on something sub standard , yet these things dont get much press play for the amount of boats they should be on i just dont hear much ,, what does ranger put on at the factory... they seem sweet.. heavy duty... i dont know ... |
|
| |
|
| There are many on the market. Hamby's makes a very good product and so does Keel guard brand. They are not that difficult to install Just follow the directions. Thats right the directions. I know that is alot to ask but take my word for it. I repeat follow the directions. |
|
| |
|
| Hamby's.
That was what was put on my Ranger and I beach that alot!
As stated follow the instructions. Mine came a little loose on the back end, I just left it that way. Doesn't hurt anything.
They are a must have for fiberglass boats if you beach them on sand or little stones.
Good luck! |
|
| |
|
Member
Posts: 91
Location: West Bend, WI | I put a keel guard on myself and it wasn't that hard. Follow the directions and you will be fine. |
|
| |
|
Member
Posts: 794
Location: Elgin, Illinois | I know a number of guys who have a Keelshield... Might look into this brand as well. Here's some info... http://www.nitroowners.com/sponsor.asp?SPONSORID=30
(Nope, not connected in any way except through my friends who have them installed on their rigs...LOL) |
|
| |
|
Member
Posts: 538
| I believe I have a Hambys on my Ranger. I had a small problem with it and Pamps in Green Bay ( my dealer) had it replaced. Give Pamps a call at 920-494-3358. They can point you in the right direction.
Take care,
Jim O |
|
| |
|
Member
Posts: 2445
Location: Fremont, Wisconsin | Most any dealer will install a keel protector. Use someone close. |
|
| |
