|
|
Member
Posts: 113
| I want to add floatation for my atv was wondering what to use to make my own there must be some instructions some where just havent found them andy help would be appreciated |
|
| |
|
Member
Posts: 2680
Location: Essexville, MI./Saginaw Bay. | Lots of ideas on-line.
http://argoparts.com/i-7822634-j-wheelz-floatation-cones-for-atv-an...
http://flightability.bizland.com/drifters_atv_floatation_system.htm
http://www.youtube.com/watch?v=WqOSZDI1CH0 |
|
| |
|
Location: Rhinelander | Nebulus.
http://www.nebulusflotation.com/ |
|
| |
|
Member
Posts: 113
| the nunulus is neat but I want to keep the atv up so if it happens the atv can be retrieved easier like on the Madison chain |
|
| |
|
Member
Posts: 197
| I have seen people take what looked like 8 inch pvc pipes and cap the ends after they filled with foam and mount them to the racks on the 4 wheeler. Front and back with 90 degree angle elbows so they cover 3 sides of the racks. I always thought the 4 wheelers would float upside down in the water but actually do not. I hope I never find out. |
|
| |
|
Member
Posts: 3899
| go to the dane county sheriffs site. They have a formula to use to determine what size to build. I used heating duct(14X8X40?), filled with 2" pink insulation. Caps on the end, and sealed with Silicone. Used ratchet straps to hold them on the ATV front and rear racks.
Edited by Shep 2/4/2013 1:00 PM
|
|
| |
