Viewing a thread - Cannot drill holes

Walleye Discussion Forums

You are logged in as a guest. ( logon | register )

	View previous thread :: View next thread
Jump to page : 1 Now viewing page 1 [25 messages per page] Walleye Fishing -> General Discussion -> Cannot drill holes

Message Subject: Cannot drill holes

Jiffy

Posted 2/11/2007 9:56 PM (#51372)
Subject: Cannot drill holes

I recently just took the burrs off my blade on my ice auger. It is a Jiffy Model 30 10 inch with a 3HP motor. My question is that once i put the blade on the same way I took it off and went to drill a hole all it does is sit and spin on the ice. It does not grab and bite and start do drill a hole. I am wondering if all you walleye gurus and other fishermen have any thoughts or comments on this. It sucks trying to spud out my holes day after day. Thanks a bunch in advance, and I hope to get some good help here.

thumper

Posted 2/12/2007 6:47 AM (#51375 - in reply to #51372)
Subject: Re: Cannot drill holes

Member

Posts: 744

Assuming it cut before, one of two things happened. Either you dulled it when you "took the burrs off" or you didn't put it back on correctly. How did you take the burrs off?

Dave S

Jump to page : 1
Now viewing page 1 [25 messages per page]

Search this forum
Printer friendly version
E-mail a link to this thread